- Application: 

     Use for 3D plane. Airplane class No about: 300-400 g (weight).

 

- Advise configure and usage limit:

     1. Advise application power 110W

     2. Momentary power 150Wmax

     3. Propose configure for this motor:

        a. Battery---1350mAh 12C 3S li-po         b. ESC---12A.     c. propeller---EP0947

        

     4. Don't let the exiguous carbon steel metal to close with motor when fixing, it breathe inside motor by magnetic field then cause the motor to set up or cause the winding short!   

        

     5. Please use the stainless steel screws when fix the motor, and the length of the screw don't higher than the pedestal, lest to breach the wire!

 

    6. Motor temperature should not exceed 90C

 

-  Configuration characteristic:

       1.  Magnet---N35SH

       2.  Silicon steel---0.35(mm)

       3.  Bearing---NMB

       4.  shaft--- Carbon steel

       5.  Guide wind system--- Free cooling

       6.  Insulated material--- Somar Epoxy (Japan)

 

- Accessories:
Front prop holder,Rear prop holder,Cross motor mount,"L" motor mount,"L" stick motor mount.

 

- Reliability Testing:

      1. Test Condition

          a. Voltage---11.1(V)                   

          b. Propeller---EP0947                               

          c. Load current---12(A)            

          d. Net Thrust---110(g)      

          e. Room temperature---25(C)             

          f. Run mode---5 Minute ON, 2 Minute OFF              

          g. Shaft direction gap--- 0.05-0.2mm        

          h. Noise no load---30db

    

     2. After testing 100 times circle

          a. Net thrust---100(g)       

          b. Current---13(A)    

          c. Temperature rising---85(C)    

          d. Shaft direction gap---0.1-0.2mm        

          e. Run mode---5 Minute ON, 2 Minute OFF